I used a 6-inch embryo and cut off both sides with a small 5-inch mold.
After cutting, the cake embryo is reversed to continue
The first half is divided into two pieces, and the second half is kept still.
The cut portion is superimposed on the second half as the tail of the lantern fish boat
The piece of embryo that is spelled has a slope, and the picture refers to the next step. Then this part can add fruit clip cream
Combined with step 5
Evenly apply the cream, the cream inside can not be considered, I used the rest of the cream state is rough, use the hand tool to repair the face, I use the transparent soft scraper
Continue to color, this part of the cream state should be careful not to be too rough
The tail part can be melted and extruded with chocolate, and the inserted part is smaller than the widest part to avoid extensive destruction of the surface.
The same propeller, I will improve it later, repair with scissors, closer to the propeller
Small wings with a smaller scraper to shave
The top lamp I made with fondant and it was fixed with wire
Finish finishing the decoration, put on the toy and you're done.